Installation

CAUTION: You will need to remove protective film on light tubes before install. Please do not assemble forcefully as it may damage the connectors or malfunction. Test lighting before final installation onto ceiling. It is recommended to consult with a licensed electrician to ensure your electrical setup is sufficient.

Step 1

Entire lighting structure should be assembled on the floor before mounting. If your kit includes a border, construct this first. If not, skip to Step 3.

Connect the longer lighting tubes with straight and 90 degree connectors to make the border. Make sure tubes are carefully inserted all the way into the connectors.

Step 2

Use a T connector at the corner of the border where a cable will plug into and connect to power supply. Please refer to power cable locations circled in your instructions diagram provided in each kit.

Step 3

Next, construct each hexagon shape into columns by connecting lighting tubes with the elbow and Y connectors to make your desired pattern.

Step 4

Place Y connectors outside of hexagons where cable will plug into and connect to power supply. Number of cables needed is dependent on the size and amount of lighting tubes (1 cable per 30 tubes). Please refer to power cable locations circled in your instructions diagram provided in each kit.

Step 5

Connect cables to 100-240V power supply and test before final ceiling installation. Red: Live / Blue: Neutral / Yellow: Earth Ground. If you are unsure on how to connect to power, we recommend consulting with a licensed electrician before proceeding.

Step 6

Raise and install to the ceiling as whole or in sections. Hang with screws through connector holes (preferred method), suspend with wire, or fasten with zip ties. Connect to power supply once installed to ceiling.